|
1.Before inspection, set the vehicle to the pre-inspection condition. 2.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector. 3.Select "Engine test" of the M.U.T.-III Special Function. 4.Select No.1 "Compression substitute test" 5.Crank the engine within 5 seconds after click the OK button until open the "Test finished"
dialog box (approximately 15 seconds). 6.Click the OK button on the dialog box. 7.Check the shown value is within the standard value.
note |
- The test should be repeated 3 times to get statistical based results.
- The value shows the deviation of engine average speed and the speed of each cylinder
while crank the engine.
|
Standard value: -6 to 6 r/min
|