REMOVAL AND INSTALLATION

			Removal steps
	>>D<<	1.	Bearing cap
	>>C<<	2.	Bearing shell 1, 2, 4 and 5
	>>B<<	3.	Bearing shell 3
	>>A<<	4.	Thrust washer
		5.	Crankshaft
		6.	Thrust washer

INSTALLATION SERVICE POINT

>>A<< THRUST WASHER INSTALLATION

Install thrust washer to crankshaft.

note

Note fixing arrangement.

>>B<< BEARING SHELL 3 INSTALLATION

Install bearing shell 3 to crankshaft.

note

For bearing cap without oil groove.
For cylinder block with oil groove.

>>C<< BEARING SHELL 1, 2, 4 and 5 INSTALLATION

Install bearing shell 1, 2, 4 and 5 to crankshaft.

note

For bearing cap without oil groove.
For cylinder block with oil groove.
Do not interchange used bearing shells.

>>D<< BEARING CAP INSTALLATION

Install bearing cap.

note

Bearing cap 1: Pulley end
Bearing cap 3 with recesses for thrust washers.
Bearing shell retaining lugs in cylinder block and bearing caps must align.