REMOVAL AND INSTALLATION


caution Always register the ignition key(s) when the engine-ECU is replaced (Refer to GROUP 42B - On-vehicle Service - ID Codes Registration Procedure ) or (Refer to GROUP 42C - On-vehicle Service - ID Codes Registration Procedure ).
Pre-removal and post-installation operation
  • Air Cleaner Assembly Removal and Installation (Refer to GROUP 15 - Air Cleaner .)




Removal steps

>>A<<
 ·
 Initialisation operation (only at installation)


1.
 Engine-ECU connector


2.
 Engine-ECU stay


3.
 Engine-ECU intermediate bracket


4.
 Engine-ECU bracket


5.
 Engine-ECU

INSTALLATION SERVICE POINT

>>A<< INITIALISATION OPERATION
Turn the ignition switch to the "ON" and then to "LOCK" (OFF) position and hold it for at least 10 seconds.