REMOVAL AND INSTALLATION

			Exhaust main muffler and rear floor panel heat protector removal steps
		1.	Exhaust main muffler
		3.	Gasket
		9.	Hunger
		10.	Rear floor panel heat protector
			Centre exhaust pipe and front floor panel heat protector removal steps
		2.	Centre exhaust pipe assembly
		3.	Gasket
		6.	Gasket
		7.	Hunger
<<A>>	>>A<<	8.	Rivet
<<A>>	>>A<<	11.	Front floor panel heat protector
			Catalytic converter removal steps
		4.	Catalytic converter
		5.	Seal ring
		6.	Gasket

REMOVAL SERVICE POINTS

<<A>> RIVET, FRONT FLOOR PANEL HEAT PROTECTOR REMOVAL

caution

Be careful not to score the heat protector by drill.

Use a 6.0 / diameter / mm drill to make a hole in the flange of rivet as shown.
2.Break the rivet, and remove the rivet and heat protector.

INSTALLATION SERVICE POINTS

>>A<< RIVET, FRONT FLOOR PANEL HEAT PROTECTOR INSTALLATION

Use a riveter to tighten the rivet by the following procedure.

1.Insert part A of rivet into the riveter, and insert the rivet into the assembling area.
2.Operate the tool’s handle while pushing the flange surface of rivet by riveter. Part A of rivet is cut and the rivet is tightened.