|
|
1.Remove the auto-cruise control switch (Refer to  ).
|
|
2.Measure the resistance between terminal 2 and terminal 3 when each of the "COAST/SET",
"ACC/RES", "CANCEL" and "ON/OFF" switches is pressed. If values measured at
the time each switch is pressed correspond to those in the table below, the resistance values are
correct.
|
|
Switch position
|
Specified condition
|
"ON/OFF" switch "OFF"
|
Open circuit
|
"ON/OFF" switch "ON"
|
Continuity (less than 2 Ω)
|
"CANCEL" switch ON
|
202.5 -
208 Ω
|
"COAST/SET" switch ON
|
610.5 -
624.5 Ω
|
"ACC/RES" switch ON
|
1838 -
1877 Ω
|
|
|
|
|
1.Disconnect the connector.
|
|
2.Check for continuity between the terminals of the switch.
|
|
Measurement condition
|
Terminal connector of tester
|
Specified condition
|
When brake pedal is depressed.
|
1 -
2 (for stoplight switch)
|
Continuity (less than 2 Ω)
|
3 -
4 (for brake switch)
|
Open circuit
|
When brake pedal is not depressed.
|
1 -
2 (for stoplight switch)
|
Open circuit
|
3 -
4 (for brake switch)
|
Continuity (less than 2 Ω)
|
|
|
|
|
1.Disconnect the clutch switch harness connector.
|
|
2.Check for continuity between the terminals of the switch.
|
|
Measurement condition
|
Terminal connector of tester
|
Specified condition
|
When clutch pedal is depressed.
|
1 -
2
|
Continuity (less than 2 Ω)
|
When clutch pedal is not depressed.
|
1 -
2
|
Open circuit
|
|
|
)
)
)