REMOVAL AND INSTALLATION


caution The fastener marked with* should be temporarily tightened first and then fully tightened with the engine weight applied on the vehicle body.
Pre-removal and post-installation operation
  • Under cover removal and installation
  • Transmission oil draining and refilling (Refer to .)
  • Transfer oil draining and refilling (Refer to .)
  • Propeller shaft removal and installation (Refer to GROUP 25 .)
  • Centre member removal and installation (Refer to GROUP 32 .)




Removal steps


1.
 Self-locking nut


·
 Drive shaft <RH> and output shaft removal and installation (Refer to GROUP 26 .)


2.
 Dynamic damper


3.
 Transfer bracket


·
 Remove the catalytic converter mounting bolts and move them to the position where they will not interfere with transfer removal (Refer to GROUP 15 ).
<<A>>
4.
 Transfer assembly


5.
 O-ring

REMOVAL SERVICE POINTS

<<A>> TRANSFER ASSEMBLY REMOVAL
Move the engine and transmission assembly toward the front of the vehicle to make a gap between the engine/transmission assembly and the crossmember. Pull out the transfer assembly through this gap.