DISASSEMBLY AND REASSEMBLY



DISASSEMBLY



1.Remove the transmission magnet.

2.Remove the bolt with washer and bearing lock plate.

3.Using special tools, remove the tapered roller bearing #1.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

4.Remove the type T oil seal.

5.Using special tools, remove the cylindrical roller bearing.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

6.Remove the type T oil seal.

7.Using special tools, remove the cylindrical roller bearing outer race.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

8.Using special tools, remove the tapered roller bearing #1.

  • Slide hammer (MB990211)
  • Slide hammer puller (MB992039)

9.Remove the output shaft cover (two pieces).

REASSEMBLY



1.Install the output shaft cover (two pieces) in the transmission case.

2.Using special tool Differential oil seal installer (MB991168), install the tapered roller bearing #1 in the transmission case.

3.Using special tool Differential oil seal installer (MB990699), install the cylindrical roller bearing outer race in the transmission case.

4.Using special tool Input shaft oil seal installer (MB992037), install the type T oil seal in the transmission case.

5.Using special tool Bush remover and installer (MB991448), install the cylindrical roller bearing in the transmission case.

6.Using special tool Extension HSG seal installer (MD998550), install the type T oil seal in the transmission case.

7.Using special tools MB990938 and MB991445, install the tapered roller bearing #1 in the transmission case.

  • Installer bar (MB990938)
  • Bush remover and installer base (MB991445)

8.Install the bearing lock plate.
9.Tighten the bolt with washer to the specified torque of 11 ± 4 N·m.

10.Install the transmission magnet in the transmission case.