|
1.Remove the transmission oil separator.
|
|
2.Using special tools, remove the tapered roller bearing #1.
- Slide hammer (MB990211)
- Slide hammer puller (MB992039)
|
|
4.Remove the type T oil seal.
|
|
5.Using special tools, remove the tapered roller bearing #1 and shim.
- Slide hammer (MB990211)
- Slide hammer puller (MB992039)
|
|
6.Remove the hole snap ring (two pieces).
|
|
7.Remove the oil receiver pipe.
|
|
1.install the oil receiver pipe in the transmission case.
|
|
2.install the hole snap ring (two pieces) in the transmission case.
|
|
3.install the shim in the transmission case.
|
|
4.Using special tool Bearing outer race installer (MB991966), install the tapered roller
bearing #1 in the transmission case.
|
|
5.Using special tool Differential oil seal installer (MB991168), install the type T oil
seal in the transmission case.
|
|
6.Install the shim in the transmission case.
|
|
7.Using special tools, install the tapered roller bearing #1 in the transmission
case.
- Installer bar (MB990938)
- Knuckle oil seal installer (MB991015)
|
|
8.Install the oil separator and tighten to the specified torque of 8.5 ± 2.5 N·m.
|