|
1.Put mating marks on the flange yoke and the electronic control coupling.
|
|
2.
| caution |
If the joint assembly is bent, it may be damaged when
pinching the joint boots.
|
Insert a rag or similar materials into the joint boots, and remove the propeller shaft
assembly by aligning the front propeller shaft with the rear shaft.
|
|
3.Using special tool plug (MB991193), cover the transfer case to prevent the entry of foreign materials.
|
|
| caution |
- Do not damage the oil seal lip of the transfer.
- The mounting bolt and nut may be loosened if oil or grease is stuck on the threads
of the bolt and nut. Tighten them after degreasing the threads.
- If the joint assembly is bent, it may be damaged when pinching the joint boots.
|
1.If the propeller shaft is reused, install the propeller shaft to the electronic control
coupling by aligning the mating mark.
2.If the propeller shaft is replaced with a new one, install it by adjusting the phases
of the propeller shaft flange and the electronic control coupling bolts.
|
)
)
)
)
)