)
Limit value: 0.05 mm
3.After checking, install the brake disc and the caliper assembly, and tighten the caliper mounting bolt to the specified torque.
Tightening torque: 100 ± 10 N·m
| 1.Remove the caliper assembly, and retain it with a wire and the like to prevent from falling. |
|
2.Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the looseness. Limit value: 0.05 mm 3.After checking, install the brake disc and the caliper assembly, and tighten the caliper mounting bolt to the specified torque. Tightening torque: 100 ± 10 N·m |