)
1.Switch the drive mode selector to the LOCK mode.
2.When the ignition switch is turned ON, the 4WD/LOCK indicators illuminate.
3.After the engine starts, the 4WD/LOCK indicators go off.
4.Otherwise, check the diagnosis code.
|
Check that the 4WD/LOCK indicators illuminate as follows: 1.Switch the drive mode selector to the LOCK mode. 2.When the ignition switch is turned ON, the 4WD/LOCK indicators illuminate. 3.After the engine starts, the 4WD/LOCK indicators go off. 4.Otherwise, check the diagnosis code. |