)
| Removal steps |
|||
| 1. |
Propeller shaft assembly (Refer to GROUP 25 -
Propeller Shaft  .) |
||
| 2. |
Cover |
||
| 3. |
Vacuum hose connection |
||
| 4. |
Connector connection |
||
| >>A<< |
5. |
Electronic control coupling |
|
|
INSTALLATION SERVICE POINTS |
>>A<< ELECTRONIC CONTROL COUPLING INSTALLATION |
) |
1.Check that the length of the electronic control coupling stud bolt (A) is within the standard
value range. Standard value: 22.3 to 25.1 mm 2.If it exceeds either of the limits, clean the threads for the electronic control coupling and replace the stud bolt. Tightening torque: 15 ± 3 N·m |