REMOVAL AND INSTALLATION


caution The part indicated * mark should be temporarily tightened and then should be fully tightened with the engine weight applied on the vehicle body.
Pre-removal and post-installation steps
  • Raise the engine and transmission assembly to the position where the weight is not applied to the engine mounting insulator.
  • Condenser Tank Removal and Installation (Refer to GROUP 14 - Radiator ).




Removal steps


1.
 Engine mounting bracket

>>A<<
 2.
 Engine mounting insulator stopper


3.
 Engine mounting insulator

INSTALLATION SERVICE POINTS

>>A<< ENGINE MOUNTING INSULATOR STOPPER INSTALLATION

Install the engine mounting insulator stopper as shown in the figure.