REMOVAL AND INSTALLATION


caution The part indicated * mark should be temporarily tightened and then should be fully tightened with the engine weight applied on the vehicle body.
Pre-removal operation
  • Jack up the engine and transmission assembly to the position where the weight is not applied to the insulator.
  • Battery and Battery Tray Removal
  • Air Cleaner Assembly Removal (Refer to GROUP 15 - Air Cleaner ).
  • Engine-ECU Removal (Refer to GROUP 13A - Engine-ECU ).

 Post-installation operation
  • Engine-ECU Installation (Refer to GROUP 13A - Engine-ECU ).
  • Air Cleaner Assembly Installation (Refer to GROUP 15 - Air Cleaner ).
  • Battery and Battery Tray Installation




Removal steps


1.
 Transmission mounting bracket


·
 Transfer assembly removal (Refer to GROUP 22A - Transmission Assembly ).

>>A<<
 2.
 Transmission mounting insulator stopper


3.
 Transmission mounting insulator

INSTALLATION SERVICE POINTS

>>A<< TRANSMISSION MOUNTING INSULATOR STOPPER INSTALLATION

Install the transmission mounting insulator stopper as shown in the figure.