REMOVAL AND INSTALLATION


caution
  • The part indicated by *1 indicates parts which should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb weight condition.
  • The parts indicated by *2 are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal operation
  • Front height sensor removal (Refer to ROUP 54A - Height sensor .)

 Post-installation operation
  • Front height sensor installation (Refer to ROUP 54A - Height sensor .)
  • Using your fingers, press the dust cover to check for a crack or damage.
  • Wheel alignment check and adjustment (Refer to .)




Removal steps


1.
 Lower arm nut


2.
 Lower arm assembly