|
|
- Check the bushings for
wear and deterioration.
- Check the stabilizer bar for deterioration or damage.
- Check all bolts for condition and straightness.
|
|
1.Move the stabilizer link ball joint stud back and forth for several times, install the
stud with nut, and measure the stabilizer link ball joint rotation starting torque using special tool
preload socket (MB990326).
Standard value: 0.5 - 2.9 N·m
2.When the measured value exceeds the standard range, replace the stabilizer link.
3.When the measured value stays within the standard range, if there is any looseness
or gritty feeling, it is judged as unusable and replaced.
|
|
|
1.Using your fingers, press the dust cover to check for a crack or damage.
|
|
|
2.If the dust cover has a crack or damage, replace the stabilizer link.
| note |
If the dust cover has a crack or damage, the ball joint could be damaged.
|
|
)