|
Replace the back side bushing according to the following procedure.
|
|
1.Use the following special tools to remove the bushing:
- MB992119 (Arm bushing remover and installer)
- MB990979 (Ring)
- MB990890 (Rear suspension bushing base)
|
|
2.Use the following special tools to press-fit the bushing.
- MB992119 (Arm bushing remover and installer)
- MB990979 (Ring)
- MB990890 (Rear suspension bushing base)
3.Press-fit the bushing so that the bushing protrusion is in the direction shown in
the figure. 4.Press-fit the bushing until the special tool contacts with the lower arm assembly.
|