)
4.Using your fingers, press the dust cover to check for a crack or damage.
| Only when the dust cover is damaged accidentally during maintenance, replace the dust
cover as follows: |
| 1.Remove the dust cover. |
| 2.Fill and apply the specified grease into the inside and lip of the dust cover. Specified grease Multipurpose grease SAE J310, NLGI No.2 or equivalent Usage: Inside of dust cover 9.0 ± 1.0 g, Lip: Adequate |
|
3.Use special tool ball joint remover & installer (MB990800) to drive in the dust
cover to the point where it contact with the lower arm assembly. 4.Using your fingers, press the dust cover to check for a crack or damage. |