DISASSEMBLY AND REASSEMBLY

			Disassembly steps
<<A>>	>>A<<	1.	Self-locking nut
		2.	Washer
		3.	Bushing B
		4.	Collar
		5.	Spring upper bracket
		6.	Bushing A
		7.	Plate
		8.	Bump rubber
		9.	Shock absorber

DISASSEMBLY SERVICE POINT

<<A>> SELF-LOCKING NUT REMOVAL

Counter the piston rod of the shock absorber as shown in the figure to remove the self-locking nut.

REASSEMBLY SERVICE POINT

>>A<< SELF-LOCKING NUT INSTALLATION

caution

The locking nut for the piston rod inside the shock absorber may be loose. Do not use an impact wrench to tighten the self-locking nut.

Counter the piston rod of the shock absorber as shown in the figure, and tighten the self-locking nut to the specified torque.
Tightening torque: 25 ± 5 N·m