|
1.Before the wheel alignment measurement, adjust the rear suspension, wheel, and tyres
in good condition.
|
|
2.Park the vehicle on a level surface to measure the wheel alignment.
|
|
If it is out of the standard range, adjust as follows:
|
|
Turn the toe adjusting bolt (the mounting bolt inside the body on the control link) to
adjust. Left wheels: Clockwise (+) Toe in Right wheels: Clockwise (-) Toe in Toe-in varies approximately 2.6 mm (equivalent to 0°16’ of
the toe angle for one side) for each scale mark.
|
|
Standard value: -0°25’ ±0°30’ (left/right difference
0°30’ max)
|
|
note |
- For vehicles with aluminium wheels, tighten special tool wheel alignment gauge attachment (MB991004)
to the specified torque, then measure the camber.
- The camber is pre-adjusted at factory and is not adjustable.
|
|