REMOVAL AND INSTALLATION



caution Do not touch the push rod in the brake booster because it is already adjusted.
Pre-removal operation
  • Brake fluid draining

  • Strut Tower Bar Removal (Refer to GROUP 42 - Strut Tower Bar ).

  • Air Cleaner Element Removal (Refer to GROUP 15 - Air Cleaner ).

Post-installation operation
  • Air Cleaner Element Installation (Refer to GROUP 15 - Air Cleaner ).
  • Brake fluid refilling and air bleeding (Refer to ).
  • Strut Tower Bar Installation (Refer to GROUP 42 - Strut Tower Bar ).





Removal steps


1.
Brake fluid level switch connector


2.
Reservoir cap


3.
Reservoir hose connection


4.
Brake pipe connection


5.
Master cylinder mounting nuts


6.
Reservoir assembly and master cylinder assembly


7.
Torx bolt


8.
Reservoir assembly


9.
Master cylinder assembly


10.
O-ring

>>B<<
11.
Vacuum hose

>>B<<
12.
Check valve


13.
Hose clip


14.
Vacuum pipe <RHD>

>>B<<
15.
Vacuum hose <RHD>


16.
Hose clip <RHD>

>>B<<
17.
Vacuum joint

>>B<<
18.
Vacuum hose


19.
Hose clip


20.
Clamp


21.
Clamp <LHD>

>>A<<
22.
Snap pin


23.
Pin assembly


24.
Brake booster mounting nut


25.
Brake booster assembly


26.
Seal

INSTALLATION SERVICE POINTS



>>A<< SNAP PIN INSTALLATION



1.Install the snap pin as shown in the figure.

>>B<< CHECK VALVE/VACUUM HOSE INSTALLATION



1.Install the check valve to the brake booster as shown in the figure.


2.Align the mark as shown in the figure to assemble the vacuum hose.