REMOVAL AND INSTALLATION


caution The vehicle speed detection encoder collects any metallic particle easily, because it is magnetised. Make sure that the encoder should not collect any metallic particle. Check that there is not any trouble prior to reassembling it.
Pre-removal and post-installation operation
  • Air cleaner body assembly removal and installation (Refer to GROUP 15 - Air Cleaner .) <Front wheel speed sensor (LH)>
  • Quarter trim removal and installation (Refer to GROUP 52A - Trim .) <Rear wheel speed sensor>




Front wheel speed sensor removal steps


1.
 Bolt (front wheel speed sensor and knuckle connection)


·
 Front wheel speed sensor connector

>>A<<
 2.
 Front wheel speed sensor grommet


3.
 Front wheel speed sensor



Rear wheel speed sensor removal steps


4.
 Rear wheel speed sensor and trailing arm assembly connection


5.
 Protector

>>A<<
 6.
 Front wheel speed sensor grommet


·
 Rear wheel speed sensor connector


7.
 Rear wheel speed sensor
note The vehicle speed detection encoder is integrated with the front wheel bearing and the rear hub assembly, which cannot be disassembled.

INSTALLATION SERVICE POINTS

>>A<< FRONT WHEEL SPEED SENSOR GROMMET/REAR WHEEL SPEED SENSOR GROMMET INSTALLATION

Install the front wheel speed sensor grommet and the rear wheel speed sensor grommet to the body panel snugly as shown in the figure.