Inspection Procedure 7: ABS system inoperative

COMMENTS ON TROUBLE SYMPTOM

In case of this trouble symptom, ABS system operation may be disabled. Diagnosis code may be set by the ABS system using scan tool.

PROBABLE CAUSES

Low battery voltage
Wiring harness or connector failure of CAN bus line
ABS-ECU malfunction

DIAGNOSIS PROCEDURE

STEP 1. Hydraulic unit check

Refer to

.

Q. Is the check result normal?

	Go to Step 2.

	Repair the brake pipe or replace ABS-ECU.

STEP 2. Operation check

Q. Does TCL/ASC operate normally?

	The procedure is complete.

	Check the brake system related components except the ABS system.