Code No. C1210 Abnormality in G and yaw rate sensor


caution If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C, Trouble code diagnosis ).

OPERATION

  • ASC-ECU supplies power to the G and yaw rate sensor at the terminal No. 1.
  • The G and yaw rate sensor outputs the signal to ASC-ECU via the CAN bus lines.

DIAGNOSIS CODE SET CONDITIONS
This diagnosis code is set if any malfunction below is found:

  • When the output value of the longitudinal G-sensor is abnormal
  • When abnormality is detected by the self-diagnosis of the longitudinal G-sensor

PROBABLE CAUSES

  • G and yaw rate sensor malfunction
  • ASC-ECU malfunction
  • External noise interference

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnosis
Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?
Go to Step 3.
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ). On completion, go to Step 2.

STEP 2. Diagnosis code recheck after resetting CAN bus lines

Q. Is the diagnosis code No. C1210 set?
Go to Step 3.
This diagnosis is complete.

STEP 3. M.U.T.-III data list
Check the following service data.

  • Item 09: G sensor

Q. Is the check result normal?
Go to Step 4.
Replace the G and yaw rate sensor, and then go to Step 5.

STEP 4. Check whether the diagnosis code is reset.

Q. Is the diagnosis code No. C1210 set?
Replace the G and yaw rate sensor, and then go to Step 5.
This diagnosis is complete.

STEP 5. Check whether the diagnosis code is reset.

Q. Is the diagnosis code No. C1210 set?
Replace the ASC-ECU.
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).