|
Steering wheel sensor outputs the signal to ASC-ECU via the CAN bus lines.
|
|
This diagnosis code is set if any malfunction below is found:
|
|
- The tolerance of neutral position of steering wheel sensor exceeds the specified
range.
- Abnormality in steering wheel sensor output value
- When abnormality is detected by comparing the value output from the steering wheel
sensor with the one from the wheel speed sensor and the G and yaw rate sensor.
|
|
- Improper installation of steering wheel sensor
- Wheel alignment not performed
- Steering wheel sensor malfunction
- Different steering wheel
- G and yaw rate sensor malfunction
- Malfunction of wheel speed sensor
- ASC-ECU malfunction
- External noise interference
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
On completion, go to Step 2.
|
|
|
|
Q.
Is the diagnosis code No. C1219 set?
|
|
This diagnosis is complete.
|
|
|
|
Check that the wheel speed sensor-related, G and yaw rate sensor-related, or steering
wheel sensor-related diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Troubleshoot the relevant diagnosis code, and then go to Step 4.
|
|
|
|
Check that the steering wheel sensor is installed correctly (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Install the steering wheel sensor correctly, and then go to Step 5.
|
|
|
|
Q.
Is the check result normal?
|
|
Adjust the wheel alignment, and then go to Step 6.
|
|
|
|
Q.
Is the diagnosis code No. C1219 set?
|
|
Replace the steering wheel sensor, and then go to Step 7.
|
|
|
|
This diagnosis is complete.
|
|
|
|
Q.
Is the diagnosis code No. C1219 set?
|
|
This diagnosis is complete.
|
|
|