| caution | After adjusting the steering angle, always perform calibration
to make ASC-ECU learn the neutral position of the steering wheel sensor (Refer to GROUP 35C,
On-vehicle Service - Steering Wheel Sensor Calibration  ).<Vehicles
with ASC> |
|
Standard value:
|
) |
1.When the calibrated value is outside the standard value, improper toe-in adjustment
may be present. Check and adjust the toe-in correctly if necessary. Standard value: 1 ± 2 mm To adjust the toe-in, remove the bellows clip of the tie-rod, loosen the locking nut, and then rotate the left tie-rod and right tie-rod in the reverse direction by an equal amount. 2.Recheck the steering angle. |