REMOVAL AND INSTALLATION



Pre-removal and post-installation operationPower Steering Fluid Draining, Refilling, Bleeding (Refer to .)




Removal steps


1.
Oil reservoir

>>C<<
2.
Suction hose

>>B<<
3.
Clip

>>B<<
4.
Hose clamp

>>B<<
5.
Return hose


6.
Power steering oil pressure sensor


7.
Eye bolt


8.
Gasket

>>A<<
9.
Pressure hose


10.
Return tube

INSTALLATION SERVICE POINTS



>>A<< PRESSURE HOSE INSTALLATION



Align the pressure hose plate as shown in the figure and connect pressure hose.

>>B<< RETURN HOSE INSTALLATION



1.Align the marking (white) as shown in the figure and connect the return hose.

2.Align the return hose marking (green) within the area shown in the figure and connect the return hose.

3.Using clip and hose clamp align the return hose marking (yellow) within the area shown in the figure and connect the return hose.

>>C<< SUCTION HOSE INSTALLATION



1.Align the oil reservoir side suction hose marking (white) within the area shown in the figure and connect the suction hose.

2.Align the oil pump side suction hose marking (green) within the area shown in the figure and connect the suction hose.