REMOVAL AND INSTALLATION



Removal steps


·
 Side air dams (Refer to GROUP 51 - Side Air Dams .)

>>A<<
 1.
 Protector film A

>>A<<
 2.
 Protector film B

INSTALLATION SERVICE POINT

>>A<< FILM INSTALLATION
Installation point


caution
  • The ambient temperature should be 20 to 38°C. Ensure that the working area is clean.
  • If ambient temperature is less than 20°C, heat the protector film and application surface to a temperature of 20 to 30°C.
  • Be careful that air bubbles are not formed under the protector film.
Installation procedure
1.Use white gasoline to degrease the protector film application surface on the doors and body.
2.Remove backing paper from the protector film, and apply the film to the specified position.