REMOVAL AND INSTALLATION


caution
  • To remove the driver airbag module, refer to GROUP 52B - Service Precautions and Driver/Front Passenger’s Air Bag Module and Clock Spring .
  • When WCM has been replaced, all key ID codes should be registered, referring to the ID code registration necessity judgment table .
Pre-removal operation
  • Lower panel and steering column cover removal (Refer to GROUP 52A - Instrument Panel Assembly ).
  • Clock spring column switch assembly removal (Refer to GROUP 37 - Steering Shaft or GROUP 52B - Driver/Front Passenger’s Air Bag Module and Clock Spring ).

 Post-installation operation
  • Clock spring column switch assembly installation (Refer to GROUP 37 - Steering Shaft or GROUP 52B - Driver/Front Passenger’s Air Bag Module and Clock Spring ).
  • Lower panel and steering column cover installation (Refer to GROUP 52A - Instrument Panel Assembly ).




Removal steps


1.
 Key ring illumination lamp

>>A<<
 2.
 WCM

INSTALLATION SERVICE POINT

>>A<< WCM INSTALATION
Check that the top claw of WCM is fixed securely to the boss of steering lock and the antenna is not floated on the key cylinder.