Code No.U0245
AUDIO VISUAL NAVIGATION UNIT CAN TIMEOUT
caution
If the diagnosis
code No. U0245 is set , be sure to diagnose the CAN bus line.
When replacing the ECU, always check that the communication circuit is normal
DIAGNOSTIC FUNCTION
If no signal from the CAN box unit (audio visual navigation unit) can be received, WCM
sets the diagnosis code No. U0245.
PROBABLE CAUSES
Malfunction of the CAN bus
Malfunctions of CAN box unit
Malfunction of WCM
Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting ).
STEP 2. M.U.T.-III other system diagnosis code
Check if diagnosis code is set to the audio visual navigation unit.
Q.
Is the diagnosis code set?
Perform the diagnosis code troubleshooting to the audio visual navigation unit.
Go to Step 3.
STEP 3. M.U.T.-III other system diagnosis code
Check if the ETACS-ECU-related diagnosis code is set.
Q.
Is the diagnosis code set?
Perform troubleshooting for ETACS-ECU (Refer to GROUP 54A -
ETACS -
Troubleshooting).
Go to Step 4.
STEP 4. Check whether the diagnosis code is reset.
Recheck if the diagnosis code is set.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Replace WCM and register the ID codes (Refer to ).
Intermittent malfunction is suspected (Refer to GROUP 00 -
How to Use
Troubleshooting/Inspection Service Points -
How to Deal with Intermittent
Malfunction ).