REMOVAL AND INSTALLATION

Door window glass assembly removal steps · Door trim assembly (Refer to GROUP 52A - Door Trim .) · Waterproof film, belt line moulding, belt line weatherstrip inner, and speaker bracket (Refer to .) 1. Door window glass assembly Power window regulator removal steps >>A<< · Post-installation operation check · Door trim assembly (Refer to GROUP 52A - Door Trim .) · Waterproof film and speaker bracket (Refer to .) <<A>> 2. Power window regulator 3. Power window motor

Door window glass assembly removal steps · Door trim assembly (Refer to GROUP 52A - Door Trim .) · Waterproof film, belt line moulding, belt line weatherstrip inner, door window glass channel, and speaker bracket (Refer to .) · Door latch assembly (Refer to .) 1. Door window glass assembly Power window regulator removal steps >>A<< · Post-installation operation check · Door trim assembly (Refer to GROUP 52A - Door Trim .) · Waterproof film and speaker bracket (Refer to .) <<A>> 2. Power window regulator 3. Power window motor

Power window switch removal · Door trim assembly (Refer to GROUP 52A - Door Trim .) 1. Power window switch panel assembly 2. Power window switch panel 3. Power window main switch <driver’s side>, power window sub switch <front passenger’s side> Power window sub switch removal · Door trim assembly (Refer to GROUP 52A - Door Trim .) 4. Power window switch panel assembly 5. Power window switch panel 6. Power window sub switch

2. caution If any film or the like is applied to the door window glass, use the window glass holder (Special tool: MB990480) at the outside of the door glass to prevent the film from peeling off. Raise the door window glass, and attach the special tool to the glass as shown to prevent the glass from dropping. 3.Remove the power window regulator.

When the following procedures are carried out, carry out the learning procedures of the power window fully closed position (Refer to ).