LEARNING PROCEDURES OF THE POWER WINDOW FULLY CLOSED POSITION



LEARNING PROCEDURES OF THE FULLY CLOSED POSITION WHEN THE POWER WINDOW SWITCH IS REMOVED, OR THE POWER WINDOW REGULATOR ASSEMBLY IS REMOVED OR REPLACED


1.If the anti-trap function (safety mechanism) is activated consecutively three times or more, the fully closed position that the power window switch has learned will be erased (initialised).
2.Operate the power window switch and fully open the door window glass.
3.
caution The anti-trap function will not activated until the learning procedures of the fully closed position have been completed (because the anti-trap function was reset).
Operate the power window switch and fully close the door window glass. The power window activates for 0.7 seconds and stops automatically when the power window switch is pressed once. Repeat this operation until the door window glass fully closes and release the switch once. Then, hold the power window switch to the fully closed side again for one second so that the power window switch completes learning the fully closed position.
note If the power window switch is operated to open the door window glass while the switch is learning, the learning will be cancelled. If this happens, return to step 2.

LEARNING PROCEDURES WHEN THE POWER WINDOW SWITCH IS REPLACED WITH A NEW ONE


caution The anti-trap function will not activated until the learning procedures of the fully closed position have been completed (because the anti-trap function was reset).
Operate the power window switch to fully close the door window glass by one-shot up action so that the power window switch will complete learning (no initialisation is required).