INSPECTION PROCEDURE
C-2: Driver’s Power Window does not work by means of The Power Window Main Switch.
caution
Before replacing the ECU,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
COMMENTS ON TROUBLE SYMPTOM
If the driver’s power window does not work by means of the power window main
switch, a malfunction of the power window main switch or the front power window motor (driver’s
side) is suspected.
PROBABLE CAUSES
Malfunction of the power window main switch
Malfunction of the front power window motor (driver’s side)
Damaged wiring harness and connectors
DIAGNOSTIC PROCEDURE
Step 1. M.U.T.-III diagnosis code
Check that ETACS-ECU sets a diagnosis code.
Q.
Is the diagnosis code set?
Refer to GROUP 54B -
Troubleshooting .
Go to Step 2.
STEP 2. Check the power window main switch.
Check that the passenger’s or rear power window works by means of the power window
main switch.
Q.
Is the check result normal?
Go to Step 3.
Refer to inspection procedure C-1 "power windows do not work at all ."
STEP 3. Connector check: E-18 power window main switch connector,
E-15 front power window motor (driver’s side) connector
Q.
Is the check result normal?
Go to Step 4.
Repair the defective connector.
STEP 4. Check of he wiring harness between the E-18 power window main
switch connector terminal Nos. 1, 7 and the E-15 front power window motor (driver’s
side) connector terminal Nos. 4, 1
Check the input/output lines for open circuit and short circuit.
Q.
Is the check result normal?
Go to Step 5.
Repair the wiring harness.
STEP 5. Retest the system.
Check that the driver’s power window works by means of the power window main
switch.
Q.
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 -
How to Use Troubleshooting/Inspection
Service Points -
How to Cope with Intermittent Malfunction ).
Replace the front power window motor (driver’s side).