INSPECTION PROCEDURE
16: Multimode Keyless Entry System Function does not work at All.
caution
Before replacing the ECU,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
OPERATION
With a ETACS customisation function, using the keyless operation key, the power windows,
sunroof, and electric-folding door mirrors can be activated.
PROBABLE CAUSES
Malfunction of the keyless operation key
Function setting error or no setting with a customisation
Malfunction of ETACS-ECU
DIAGNOSTIC PROCEDURE
STEP 1. Check the keyless entry system operation.
Check that the keyless entry system works normally.
Q.
Is the check result normal?
Go to Step 2.
Refer to inspection procedure 13 "keyless entry system does not work ."
STEP 2. Check the customisation
Use the customisation function to check that the "Multi mode" has been set to other than
"Disabled."
Q.
Is it set to other than "disabled"?
Go to Step 3.
Use the customisation function to set the "Multi mode" to other than "Disabled"
(Refer to ).
STEP 3. M.U.T.-III diagnosis code
Check whether a KOS-related diagnosis code is set.
Q.
Is the diagnosis code set?
Refer to .
Go to Step 4.
STEP 4. Check of the troubles
Check that the multimode keyless entry system works normally.
Q.
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00 -
How to Use Troubleshooting/Inspection
Service Points -
How to Deal with Intermittent Malfunction ).
Replace ETACS-ECU. After the replacement, perform the coding.