INSPECTION PROCEDURE
14: Auto Lock Function does not Work.
caution
Before replacing the ECU,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
OPERATION
When a driver brings the keyless operation key out of the passenger’s compartment,
closes all the doors, and leaves the keyless operation key certification area outside the vehicle,
all the doors are automatically locked. However, if an open signal from any door or ignition
push switch ON signal has been input to ETACS-ECU, the auto lock function will not operate.
PROBABLE CAUSE
Malfunction of ETACS-ECU
DIAGNOSTIC PROCEDURE
STEP 1. M.U.T.-III diagnosis code
Check whether a KOS-related diagnosis code is set.
Q.
Is the diagnosis code set?
Refer to .
Go to Step 2.
STEP 2. Check of the troubles
Check that the auto lock operates normally.
Q.
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00 -
How to Use Troubleshooting/Inspection
Service Points -
How to Cope with Intermittent Malfunction ).
Perform troubleshooting for each door switch (Refer to GROUP 54A -
ETACS -
Troubleshooting ).