Code No.U0164 A/C CAN timeout



caution
  • If the diagnosis code No. U0164 is set, be sure to diagnose the CAN bus line.
  • When replacing the ECU, always check that the communication circuit is normal.

DIAGNOSIS FUNCTION


If no signal from A/C-ECU can be received, KOS-ECU sets the diagnosis code No. U0164.

PROBABLE CAUSES




DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnostics


Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?

Go to Step 2.

Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ). On completion, go to Step 2.

STEP 2. M.U.T.-III other system diagnosis code


Check if the A/C-ECU-related diagnosis code is set.

Q. Is the diagnosis code set?

Perform troubleshooting for A/C-ECU (Refer to GROUP 55 - Troubleshooting ).

Go to Step 3.

STEP 3. M.U.T.-III other system diagnosis code


Check if the ETACS-ECU-related diagnosis code is set.

Q. Is the diagnosis code set?

Perform troubleshooting for ETACS-ECU (Refer to GROUP 54A - ETACS - Troubleshooting ).

Go to Step 4.

STEP 4. Check whether the diagnosis code is reset.


Recheck if the diagnosis code is set.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

Replace KOS-ECU and register the ID codes (Refer to ).

Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Deal with Intermittent Malfunction ).