REMOVAL AND INSTALLATION


caution Before installing the roof drip moulding, the windshield adhesive remained on the clip installation points should be removed 3 to 5 mm from the edge of the glass. However, if the windshield adhesive has not been cured yet, it is not necessary to remove it.




Roof drip moulding removal steps


1.
 Roof carrier cap A <Vehicles with commercial roof rail>


2.
 Roof carrier cap B <Vehicles with commercial roof rail>
<<A>>
3.
 Roof drip moulding


4.
 Clip A (Red)


5.
 Clip B (Orange)


6.
 Clip C (Pink)


7.
 Clip D


8.
 Clip E


REMOVAL SERVICE POINT

<<A>> ROOF DRIP MOULDING REMOVAL

1.
note Use a commercial available ornament remover (resin-made) as shown to pry out the roof drip moulding.