|
Inspect the rear wiper motor by disconnecting the harness connector with the motor attached to the vehicle.
|
|
|
Connect the battery to the rear wiper motor to inspect the motor operation as shown in the illustration.
|
|
|
- Connect the battery to the rear wiper motor as shown in the illustration.
- Disconnect the battery in the middle of the motor rotation and check to see that the motor stops.
- Reconnect the battery.
- Check to see that the rear wiper motor runs and then stops at the automatic stop position.
|
|
1.The rear washer motor must be checked with the washer tank installed and the washer fluid filled.
2.Connect the battery to the washer motor connector as shown. Check that the washer motor delivers washer strongly to the rear washer hose side.
|
|
|
Adjust the nozzle so that it injects washer fluid to the range shown.
|
|
|
The rear wiper and washer switch can be checked for proper operation by confirming ETACS diagnosis code. (Refer to GROUP 54A - ETACS  )
|
)
)
)