REMOVAL AND INSTALLATION



caution To remove the front seat assembly of vehicle with side air bag, refer to GROUP 52B - Service Precautions and Curtain Air Bag Module .




Removal steps


1.
Headrest


2.
Front seat anchor cover


3.
Rear seat anchor cover
<<A>>

·
Wiring harness connectors

>>A<<
4.
Front seat assembly

REMOVAL SERVICE POINT



<<A>> WIRING HARNESS CONNECTOR DISCONNECTION



Disconnect the following wiring harness connectors:
Connector number
Connector name
D-25 (4 - black)
Heated seat connector (front passenger’s seat) <Vehicle with heated seat>
D-26 (2 - black)
Seat belt switch connector (front passenger’s seat)
D-27 (2 - yellow)
Side air bag module (squib) connector (front passenger’s seat) <Vehicles with side air bag>
D-29 (2 - yellow)
Side air bag module (squib) connector (driver’s seat) <Vehicles with side air bag>
D-30 (2 - black)
Seat belt switch connector (driver’s seat)
D-31 (4 - black)
Heated seat connector (driver’s seat) <Vehicle with heated seat>
D-32 (2)
Power seat connector (driver’s seat) <Vehicle with power seat>

INSTALLATION SERVICE POINT



>>A<< FRONT SEAT ASSEMBLY INSTALLATION



1.Confirm that both the seat slides are locked, and then temporarily tighten all the bolts shown in the figure so that no load is applied to the front seat cushion.
2.Tighten all the bolts to the specified torque.
Tightening torque: 43 ± 8 N·m