REMOVAL AND INSTALLATION


warning
  • Never attempt to disassemble or repair the passenger’s air bag cut off switch. If faulty, replace it.

  • Do not drop or subject the passenger’s air bag cut off switch to impact or vibration. Replace the passenger’s air bag cut off switch, if a dent, cracking, deformation, or rust is present.
Pre-removal Operation
  • Turn the ignition key to the "LOCK" (OFF) position.
  • Disconnect the negative (-) battery terminal.




Removal steps


·
 Glove box assembly, glove box side panel, side air outlet (Refer to GROUP 52A - Instrument panel assembly ).


1.
 Passenger’s air bag cut off switch and bracket assembly


2.
 Passenger’s air bag cut off switch


3.
 Passenger’s air bag cut off switch bracket



Installation steps

>>A<<
 ·
 Pre-installation inspection


3.
 Passenger’s air bag cut off switch bracket

>>B<<
 2.
 Passenger’s air bag cut off switch


1.
 Passenger’s air bag cut off switch and bracket assembly


·
 Glove box assembly, glove box side panel, side air outlet (Refer to GROUP 52A - Instrument panel assembly ).

>>C<<
 ·
 Post-installation inspection

INSTALLATION SERVICE POINTS

>>A<< PRE-INSTALLATION INSPECTION
Check the passenger’s air bag cut off switch for dents, breakage and bending and measure the resistance between the terminals, even when installing a new passenger’s air bag cut off switch.

>>B<< PASSENGER’S AIR BAG CUT OFF SWITCH INSTALLATION
warning If the passenger’s air bag cut off switch is not installed securely and correctly, the passenger’s (front) air bag may not operate normally.
Securely connect the connector.

>>C<< POST-INSTALLATION INSPECTION
1.Turn the ignition switch to the "ON" position.

2.Check that the SRS warning lamp is illuminated for 6 to 8 seconds, and extinguished afterward.
3.If the lamp does not extinguish, perform the troubleshooting.

4.Turn the ignition switch to the "ON" position.
5.Check that the passenger’s air bag OFF indicator lamp is illuminated for 6 to 8 seconds, and extinguished afterward.
6.If the lamp does not extinguish, perform the troubleshooting.