REPLACE THE BULB



HEADLAMP BULB (LOW-BEAM) REPLACEMENT <VEHICLES WITHOUT DISCHARGE HEADLAMP>


caution Do not touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, immediately clean it with alcohol or thinner. After drying completely, install the bulb.

Disconnect the connector, and twist the headlamp bulb (low-beam) to remove.

HEADLAMP BULB (HIGH-BEAM) REPLACEMENT


caution Do not touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, immediately clean it with alcohol or thinner. After drying completely, install the bulb.

Disconnect the connector, and twist the headlamp bulb (high-beam) to remove.

POSITION LAMP BULB REPLACEMENT


caution Do not touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, immediately clean it with alcohol or thinner. After drying completely, install the bulb.

Disconnect the connector, and twist the position lamp socket to remove it.

FRONT TURN-SIGNAL LAMP BULB REPLACEMENT


caution Do not touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, immediately clean it with alcohol or thinner. After drying completely, install the bulb.

Disconnect the connector, and twist the front turn-signal lamp socket to remove it.