Inspection Procedure
9: The Wiper-linked Auto Lamp Function does not Work Normally.
caution
Whenever the ECU is replaced,
ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
OPERATION
The ETACS-ECU operates this function in accordance with the input signals below.
Auto lamp switch
Windshield wiper switch
COMMENTS ON TROUBLE SYMPTOM
If this function does not work normally, the above switch input circuit(s) or ETACS-ECU
may have a problem.
PROBABLE CAUSES
Malfunction of the lighting switch
Malfunction of windshield wiper switch
Malfunction of the ETACS-ECU
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. ETACS-ECU customise function check
Use the ETACS-ECU customise function to check that the "Auto light linked wiper" is set
to "Enable."
Q.
Is the check result normal?
Go to Step 2.
Use the SWS monitor customise function to set the "Auto light linked wiper" to
"Enable" (Refer to ).
STEP 2. Windshield wipers operation check
Check that the windshield wipers work normally by operating the relevant switches.
Q.
Is the check result normal?
Go to Step 3.
Troubleshoot the windshield wiper (Refer to GROUP 51 -
Windshield wiper
and washer -
Troubleshooting ).
STEP 3. Check the auto lamp function operation.
Check that the auto lamp function works normally.
Q.
Is the check result normal?
Go to Step 4.
Refer to Inspection Procedure 8 "The auto lamp function does not work normally" .
STEP 4. Retest the system
Check that the wiper-linked auto-lamp function works normally.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 -
How
to use Troubleshooting/inspection Service Points -
How to Cope with Intermittent
Malfunction ).