Inspection Procedure 12: The Turn-signal Lamps do not Illuminate.




COMMENTS ON TROUBLE SYMPTOM


If all the turn-signal lamps do not illuminate, the ignition switch (IG1), the turn-signal lamp switch input circuit or the ETACS-ECU may have a problem.

PROBABLE CAUSES




DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III diagnosis code


Check if diagnosis code is set to the ETACS-ECU.

Q. Is the diagnosis code set?

Troubleshoot the ETACS-ECU. Refer to .

Go to Step 2.

STEP 2. M.U.T.-III data list


Using the ETACS-ECU service data, check the signals related to the illumination of turn-signal lamp.

Item No.
Item name
Normal condition
Item 254
IG voltage
Battery voltage
OK: Normal condition is displayed.

Q. Is the check result normal?

Go to Step 3.

Troubleshoot the ETACS-ECU. Refer to Inspection Procedure 2 "The ignition switch (IG1) signal is not received" .

STEP 3. Retest the system


Check that the turn-signal lamps illuminate.

Q. Is the check result normal?

The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).

Replace the ETACS-ECU.