Inspection Procedure 10: Daytime Running Lamp Function does not Work Normally.
caution
Whenever the ECU is replaced, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.
COMMENTS ON TROUBLE SYMPTOM
If the daytime running lamp function is not operating normally the ETACS-ECU power circuit may be defective or the ETACS-ECU may be defective.
PROBABLE CAUSES
Malfunction of the ETACS-ECU
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Check the operation of the headlamps.
Check that the low-beam headlamps illuminate normally.
Q.
Is the check result normal?
Go to Step 2.
Refer to Inspection Procedure 1 "The low-beam headlamps do not illuminate normally." .
STEP 2. M.U.T.-III diagnosis code
Check if diagnosis code is set to the ETACS-ECU.
Q.
Is the diagnosis code set?
Troubleshoot the ETACS-ECU. Refer to .
Go to Step 3.
STEP 3. Retest the system
Check that the daytime running lamp illuminate normally.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 -
How to use Troubleshooting/inspection Service Points -
How to Cope with Intermittent Malfunction ).