With the ignition switch at the ON position, if the chassis number code is not written
to the combination meter, diagnosis code No. B2203 is stored.
PROBABLE CAUSES
Malfunction of CAN bus line
Malfunction of the ETACS-ECU
Malfunction of combination meter
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting ).
STEP 2. M.U.T.-III other system diagnosis code
Check again if the diagnosis code is set to the ETACS-ECU.
Q.
Is the diagnosis code set?
Troubleshoot the ETACS-ECU. Refer to ETACS-ECU -
Diagnosis code chart .
Go to Step 3.
STEP 3. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to the combination meter.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the combination meter.
The trouble can be an intermittent malfunction (Refer to GROUP 00 -
How
to use Troubleshooting/inspection Service Points -
How to Cope with Intermittent
Malfunction ).