Inspection Procedure
6: The tachometer does not work (the other meters work).
COMMENTS ON TROUBLE SYMPTOM
If only the tachometer does not operate, the ignition signal from the engine ECU may not
be received or the combination meter may have a problem.
PROBABLE CAUSES
- Malfunction of combination meter
- Malfunction of engine ECU
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ). Complete
the CAN troubleshooting, and then go to Step 6.
STEP 2. M.U.T.-III diagnosis code
Check if diagnosis code is set to the combination meter.
Q.
Is the diagnosis code set?
Troubleshoot the combination meter. Refer to .
Complete the combination meter troubleshooting, then go to Step 6.
Go to Step 3.
STEP 3. M.U.T.-III other system diagnosis code
Check if diagnosis code is set to the engine-ECU.
Q.
Is the diagnosis code set?
Troubleshoot the engine control system. Refer to GROUP 13A - Troubleshooting .
Complete the engine troubleshooting, and then go to Step 6.
Go to Step 4.
STEP 4. M.U.T.-III data list
- Item 87: Tachometer (Refer to .)
Q.
Is the check result normal?
Go to Step 5.
Troubleshoot the engine control system. Refer to GROUP 13A - Troubleshooting .
Complete the engine troubleshooting, and then go to Step 6.
STEP 5. M.U.T.-III actuator test
OK: The tachometer operates up to the set position.
Q.
Is the check result normal?
Go to Step 6.
Replace the combination meter, and then go to Step 6.
STEP 6. Retest the system
Check that the tachometer works normally.
Q.
Is the check result normal?
The procedure is complete.
Go to Step 1.