)
| Terminal No. |
Check items |
Check condition |
Normal condition |
|
| 1 |
Power supply from ignition switch (IG1) |
Ignition switch: ON |
System voltage |
|
| 2 |
Headlamp levelling unit (LH) power supply |
Ignition switch: ON |
System voltage |
|
| 3 |
Output to the headlamp levelling unit (LH) |
Ignition switch: ON |
When the levelling motor is stopped |
0 V |
| When the levelling motor is operating |
10%
-
90%
of system voltage |
|||
| 4 |
Headlamp levelling unit (LH) earth |
Always |
0 V |
|
| 5 |
Output of diagnosis signal |
At reading of diagnosis code |
1.5 V or less |
|
| 6 |
Headlamp relay (LO) ON signal |
Headlamp: ON |
System voltage |
|
| 7 |
Output of the pulse check signal |
Ignition switch: ON |
0 V to System voltage (pulse signal) |
|
| 8 |
Output of the headlamp automatic levelling warning display |
Ignition switch: ON Warning display illumination |
1.2 V or less |
|
| 9 |
Input of vehicle speed signal |
Perform a test run of the vehicle. |
0 V to System voltage (pulse signal) |
|
| 11 |
Headlamp levelling unit (RH) power supply |
Ignition switch: ON |
System voltage |
|
| 12 |
Output to the headlamp levelling unit (RH) |
Ignition switch: ON |
When the levelling motor is stopped |
0 V |
| When the levelling motor is operating |
10%
-
90%
of system voltage |
|||
| 13 |
Headlamp levelling unit (RH) earth |
Always |
0 V |
|
| 14 |
Earth |
Always |
0 V |
|
| 15 |
Front height sensor power supply |
Ignition switch: ON |
5 V |
|
| 16 |
Rear height sensor power supply |
Ignition switch: ON |
5 V |
|
| 17 |
Input from front height sensor |
Ignition switch: ON |
0.5 -
4.5 V |
|
| 18 |
Input from the rear height sensor |
Ignition switch: ON |
0.5 -
4.5 V |
|
| 19 |
Front height sensor earth |
Always |
0 V |
|
| 20 |
Rear height sensor earth |
Always |
0 V |
|