Terminal No.
|
Check item
|
Check condition
|
Normal condition
|
1
|
Back-up lamp switch "ON" position input
|
- Ignition switch to "ON" position.
- Shift the selector lever to any position other than "R" (reverse).
|
0 V
|
- Ignition switch to "ON" position
- Shift the selector lever to "R" (reverse) position.
|
System voltage
|
3
|
Input of ignition switch (IG1) signal
|
Ignition switch: ON position
|
0 V to system voltage
|
6
|
Back sensor (RH)
|
Ignition switch: ON position
|
0V (40kHz pulse signal, emitted approx. every 125ms)
|
7
|
Corner sensor (rear: LH)
|
Ignition switch: ON position
|
0V (40kHz pulse signal, emitted approx. every 125ms)
|
8
|
Corner sensor (rear: RH)
|
Ignition switch: ON position
|
0V (40kHz pulse signal, emitted approx. every 125ms)
|
9
|
Back sensor (LH)
|
Ignition switch: ON position
|
0V (40kHz pulse signal, emitted approx. every 125ms)
|
10
|
Sensor earth
|
Ignition switch: ON position
|
0 V
|
11
|
Power supply to the ignition switch (IG1)
|
Ignition switch: ON position
|
System voltage
|
12
|
Reversing sensor indicator output
|
- Ignition switch: ON position
- Sonar switch input: OFF
|
0 V
|
- Ignition switch: ON position
- Sonar switch input: ON
|
System voltage
|
13
|
Sonar switch input
|
- Ignition switch: ON position
- Sonar switch input: OFF
|
System voltage
|
- Ignition switch: ON position
- Sonar switch input: ON
|
0 V
|
20
|
Earth
|
Always
|
0 V
|
)