REMOVAL AND INSTALLATION


caution To remove the driver airbag module, refer to GROUP 52B - Service Precautions and Driver/Front Passenger’s Air Bag Module and Clock Spring .
Pre-removal Operation
  • Removal of lower panel and steering column cover (Refer to GROUP 52A - Instrument Panel Assembly ).
  • Removal of clock spring/column switch assembly (Refer to GROUP 37 - Steering Shaft and GROUP 52B - Driver’s/front passenger’s air bag module and clock spring ).

 Post-installation Operation
  • Installation of clock spring/column switch assembly (Refer to GROUP 37 - Steering Shaft and GROUP 52B - Driver’s/front passenger’s air bag module and clock spring ).
  • Installation of lower panel and steering column cover (Refer to GROUP 52A - Instrument Panel Assembly ).




Removal Steps


1.
 Ignition switch


2.
 Key reminder switch


3.
 Key ring illumination lamp <Vehicles for KOS (with dead lock system) and WCM>


4.
 WCM <vehicles with WCM>/receiver antenna module <vehicles with KOS>
< <A> >
5.
 Steering lock cylinder <vehicles with WCM>

REMOVAL SERVICE POINTS

<<A>> STEERING LOCK CYLINDER REMOVAL <VEHICLES WITH WCM>
1.Insert the key into the steering lock cylinder, and turn the ignition key to the ACC position.

2.With using a cross-headed screw driver (small) or similar items to press in the lock pin, remove the ignition key, and then remove the steering lock cylinder.