When the hazard warning lamp fuse is blown, the ETACS-ECU sets the diagnosis code No. B16A6.
JUDGMENT CRITERIA
With the ADC diagnosis code not set, when the blown fuse of hazard warning lamp is detected three times consecutively, the ETACS-ECU sets the diagnosis code No. B16A3.
PROBABLE CAUSES
Damaged harness wires and connectors
Malfunction of the ETACS-ECU
DIAGNOSIS PROCEDURE
STEP 1. Fuse check
Check if the turn-signal lamp fuse is normal.
Q.
Is the check result normal?
Go to Step 2.
Replace the turn-signal lamp fuse.
STEP 2. Check whether the diagnosis code is reset.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.